Dynapac SD2500W - 5.1 Mounting extension parts; Mount auger extension

E 13 25
5.1 Mounting extension parts
Mount auger extension
m
Before pulling the gear off, the auger extremities must be supported with a block of
wood or similar to prevent any damage.
- Loosen the clamping bolts (1) on the support tube. Then turn in the centre expan-
sion bolt (2) to expand the clamping joint.
- Pull the telescopic tube (3) out of the support tube (4).
m
Collision between the hydraulic hoses
and the steel cable of the height display!
Remove the steel cable (A) from the
bracket (B). After the support tube has
been pulled out, hang the steel cable
back in position again.
1
2
3
4
5
6
B
A