Dynapac SD2500W User Manual

F 51 5
1.2 Points of maintenance
Engine fuel tank (1)
- Check the filling level on the gauge
on the operating panel.
A
Fill the fuel tank each time before start-
ing work so that the fuel system cannot
"run dry" and time-consuming venting
(bleeding) can therefore be avoided.
For filling in the fuel:
- Remove cap (A).
- Fill in fuel through the filling port until
the required fill lever is achieved.
- Replace the cap (A).
Clean the tank and system:
- Unscrew the drain plugs (B) in both
tanks and drain about 1 l fuel into a
collection pan.
- When fastening the screw again after
draining, make sure to use a new seal.
A
B
B

Dynapac SD2500W Specifications

General

Brand	Dynapac
Model	SD2500W
Category	Construction Equipment
Language	English