F 10 1
F 10 Maintenance
1 Notes regarding safety
f
Maintenance work: Maintenance work may only be carried out when the engine is
at a standstill.
Secure the paver finisher and the attachments against inadvertent starting before be-
ginning any maintenance work:
- Set the drive lever to the centre position and the speed preselector to zero.
- Pull out the ignition key and the battery main switch.
f
Lifting and jacking up: Secure lifted machine parts (e.g. screed or hopper) against
lowering by means of mechanical supports.
m
Spare parts: Use only approved parts and install them according to the specifica-
tions! If in doubt, contact the manufacturer!
f
Re-commissioning: Mount all protective devices before re-commissioning the paver
finisher.
f
Cleaning: Cleaning must not be carried out while the engine is running.
Do not use any inflammable substances (such as petrol).
Avoid directly cleaning electrical parts and insulation material with a steam jet; cover
them up beforehand.
f
Working in enclosed environments: Exhaust fumes must be conducted into the
open air. Propane gas bottles must not be stored in closed rooms.
m
In addition to these maintenance instructions, the maintenance instructions issued by
the engine manufacturer must be adhered to under all circumstances. All mainte-
nance work and service intervals itemised here are binding in nature.
A
Information on how to maintain the optional equipment can be found in the individual
sub-sections of this chapter!
To Next Page
Loading...
Need help?
General
