Dynapac SD2500W - 6 Protective roof (o)

C 13 14
6 Protective roof (o)
The protective roof can be raised and
lowered with a manual hydraulic pump.
A
The exhaust pipe is lowered or raised to-
gether with the roof.
- Remove the lower section of the pump
lever (1) from the storage compart-
ment, and connect to the upper sec-
tion using a pipe (2).
- Lower the roof: The locks (3) on both
sides of the roof must be released.#
- Raise the roof: The locks (4) on both
sides of the roof must be released.
- Set the adjustment lever (5) to the
"Raise" or "Lower" position.
- Raise the roof: The lever points for-
wards.
- Lower the roof: The lever points
backwards.
- Operate the pump lever (1) until the roof has reached the upper or lower limit posi-
tion.
- Roof in uppermost position: Set the locks (3) on both sides of the roof.
- Roof lowered: Set the lock (4) on both sides of the roof.
m
If the vehicle is equipped with a protective roof, the engine hood must be closed be-
fore lowering the roof!
5
3
1
2
4