Dynapac SD2500W - Operating panel, moveable; Operating panel, swivelling (o); Control platform lock (o)

D 31 5
Operating panel, moveable
The operating panel can be shifted to several positions on the left- and right-hand
sides of the vehicle.
- Release panel latch (2) and slide panel console to the desired position using the
handle (3).
- Insert panel latch (2) into one of the detent positions (4).
m
Make sure it is latched properly!
f
Only adjust the operating position whilst the vehicle is stationary!
Operating panel, swivelling (o)
The entire operating panel can be swivelled for operation beyond the outer edge of
the vehicle.
- Press latch (5), swivel operating panel to the required position using the handle (3)
and allow latch to engage again in one of the intended detent positions.
m
Make sure it is latched properly!
f
Only adjust the operating position whilst the vehicle is stationary!
Control platform lock (o)
f
During transportation in road traffic and when transporting the vehicle on transport-
ers, the control panel must be secured in the central position!
- Remove the locking pin (7) from its storage compartment (press pushbutton) and
insert into locking aperture (8).
m
To be able to set the lock, the panel must be positioned centrally above the machine
frame.