EasyManuals Logo

Dynapac SD2500W User Manual

Dynapac SD2500W
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #251 background imageLoading...
Page #251 background image
D 43 7
External starting (starting aid)
A
The engine can be started with the help of an external power source if the batteries
are empty and the starter no longer turns.
Suitable power sources are:
- Other vehicles with a 24 V system
- Additional 24 V battery
- Start device that is suitable for external starting (24 V/90 A).
m
Standard chargers or quick chargers cannot be used for external starting.
To externally start the engine:
- Switch on the ignition (11), set the drive lever (13) to the centre position and the
travel drive preselector (15) to minimum.
- Use appropriate cables to connect the external power source.
m
Observe the polarity! Always connect the negative cable last and disconnect it first!
A
It is impossible to start the vehicle if an emergency stop button (10) / (120) is de-
pressed.
(Error shown on the display)
- Press the starter button (12) to start the engine. Do not let the starter run perma-
nently for more than 30 seconds; allow for a break of 2 minutes after every attempt!
When the engine is running:
- Disconnect the power source

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac SD2500W and is the answer not in the manual?

Dynapac SD2500W Specifications

General IconGeneral
BrandDynapac
ModelSD2500W
CategoryConstruction Equipment
LanguageEnglish

Related product manuals