D 31 21
- Once the sensor rod has been set to the desired width, the clamping bolts (2) must
be tightened again.
- The inserted sensor rod extension is secured with the bolts (4).
A
Depending on the side of the vehicle on which the sensor rod extension is used, the
entire sensor rod may have to be removed and re-inserted on the other side of the
vehicle!
- After releasing the wing nuts (5), the end section of the sensor rod extension (6)
can be set to the desired length; the angle can additionally be changed by swivel-
ling on the joint (7).
A
Either the adjustable indicator or the chain can be used as an aid to orientation.
m
Tighten all assembly parts properly after setting up!
A
The sensor rod extension's joint (7) can be mounted on both sides of the vehicle in
position (8).
At this point, the sensor rod extension can be swivelled in for transporting the vehicle
without increasing the vehicle's basic width.
To Next Page
Loading...
Need help?
General
