EasyManuals Logo

Dynapac SD2500W User Manual

Dynapac SD2500W
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
C 13 19
A
Four lifting eyes (1, 2) are provided for loading the vehicle with a crane.
A
Depending on the type of screed which is used, the paver finisher's centre of gravity
(3), with the screed mounted, is located in the area of the leading edge of the rear
wheel.
- Secure vehicle wherever it is parked up.
- Engage the transport safeguards.
- Remove any attachments and extension parts from the paver finisher and the
screed until the basic width has been attained.
- Take off all protruding or loose parts and the gas bottles of the screed heater (see
chapters E and D).
- Lower the protective roof (o):
A
See section entitled "Protective roof"
- Attach lifting gear to the four attachment points (1, 2).
m
The max. permissible attachment point load is 73.5 kN.
m
The permissible load applies in the vertical direction!
m
Make sure that the paver finisher remains in a horizontal position during transportation!

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac SD2500W and is the answer not in the manual?

Dynapac SD2500W Specifications

General IconGeneral
BrandDynapac
ModelSD2500W
CategoryConstruction Equipment
LanguageEnglish

Related product manuals