D 13 7
Item Designation Brief description
13
Drive lever
(traction)
For switching on the paver finisher functions and for continu-
ously regulating the road speed – forward or reverse.
Zero position: Engine in neutral; no travel drive;
- To swivel the drive lever out, release by pulling the handle
up.
Depending on the position of the drive lever, the following func-
tions can be activated:
1. position:
- Conveyor and auger on.
2. position:
- Screed motion (tamper/vibration) on; travel
drive on; increase speed until the stop is reached.
A
Use the preselector to set the maximum speed.
f
The vehicle speed cannot be reduced to "0" with the
preselector. The machine advances slightly with de-
flected drive lever, even if the travel drive preselector is
set to "zero"!
A
If the engine is started with the drive lever pivoted out,
the travel drive is inhibited.
To start the travel drive, first the drive lever must be re-
turned to the centre position.
A
When changing over between forwards and reverse tra-
vel, the drive lever must remain briefly in neutral.
To Next Page
Loading...
