Electrolux Built-in ovens - Removing the Convection Fan Blade; Access to the Fan Blade and the Convection; Heating Element

SOI 02.10 FV 35/142 599 70 59-01
2.4.10 - REMOVING THE CONVECTION FAN BLADE
Proceed as follows to remove the convection fan blade:
- Remove the grids and drip pans from the inside of the oven.
- Remove the oven bottom panel by unscrewing the 2 fixing screws and slide it upwards
(see Fig. 67).
Fig. 67
1 - FIXING SCREWS FOR
OVEN BOTTOM PANEL
2 - OVEN BOTTOM PANEL
3 - FIXING TABS FOR
OVEN BOTTOM PANEL
4 - SIDE GRIDS
2.4.11 - ACCESS TO THE FAN BLADE AND THE CONVECTION HEATING ELEMENT
Once the oven back panel has been removed, the following components are accessible: the
convection fan and the circular convection heating element.
Fig. 68
1 - GRILL/TOP
HEATING ELEMENT
2 - FIXING SCREW FOR THE
GRILL/TOP
HEATING ELEMENT
3 - LAMPHOLDER
4 - CONVECTION FAN
5 - FIXING SCREW FOR THE
CONVECTION FAN
6 - FIXING SCREWS FOR THE
CONVECTION HEATING
ELEMENT
7 - CONVECTION HEATING
ELEMENT
8 - SIDE GRIDS