SOI 02.10 FV 62/142 599 70 59-01
2.6.3.10 - REMOVING THE TANGENTIAL FAN ON VISION ELECTRONIC
PYRO VERSION
To remove one of the components:
1 - Unfasten the fixing screws on the upper panel.
2 - Detach the connection wires for the tangential cooling fan.
3 - Unfasten the fixing screws on the fan.
4 - Extract the component.
Fig. 117
1 - VISION CONTROL UNIT
2 - DOOR LOCK
3 - SAFETY
THERMOSTAT
4 - LIGHT BAR
POWER BOARD
5 - DROP RESISTOR
6 - TANGENTIAL FAN
MOTOR
7 - TANGENTIAL FAN
8 - POWER BOARD
OVC2000
Fig. 118
1 - FIXING SCREWS FOR
COOLING FAN
2 - TANGENTIAL
COOLING FAN
3 - TANGENTIAL COOLING
FAN MOTOR
4 - ELECTRICAL CONTACTS FOR
CONNECTION
To Next Page
Loading...
