Endress+Hauser Proline Promass E 500 - Page 123

Proline Promass E 500 PROFIBUS PA Commissioning
Endress+Hauser 123
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Failure mode The Pulse option is selected in
the Operating mode
parameter (→  121) and a
process variable is selected in
the Assign pulse output
parameter (→  122).
Define output behavior in
alarm condition.
• Actual value
• No pulses
–
Invert output signal – Invert the output signal. • No
• Yes
–
* Visibility depends on order options or device settings
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  124
Terminal number
→  124
Signal mode
→  124
Assign frequency output
→  125
Minimum frequency value
→  125
Maximum frequency value
→  126
Measuring value at minimum
frequency
→  126
Measuring value at maximum
frequency
→  126
Failure mode
→  126
Failure frequency
→  126
Invert output signal
→  126