Endress+Hauser Proline Promass E 500 - Page 130

Commissioning Proline Promass E 500 PROFIBUS PA
130 Endress+Hauser
Relay output function
→  130
Assign flow direction check
→  130
Assign limit
→  131
Assign diagnostic behavior
→  131
Assign status
→  131
Switch-off value
→  131
Switch-off delay
→  131
Switch-on value
→  131
Switch-on delay
→  132
Failure mode
→  132
Switch status
→  132
Powerless relay status
→  132
Parameter overview with brief description
Parameter Prerequisite Description User interface /
Selection / User
entry
Factory setting
Terminal number – Shows the terminal numbers
used by the relay output
module.
• Not used
• 24-25 (I/O 2)
–
Relay output function – Select the function for the
relay output.
• Closed
• Open
• Diagnostic
behavior
• Limit
• Flow direction
check
• Digital Output
–
Assign flow direction check The Flow direction check
option is selected in the Relay
output function parameter.
Select process variable for flow
direction monitoring.
–