Endress+Hauser Proline Promass E 500 - Page 168

Operation Proline Promass E 500 PROFIBUS PA
168 Endress+Hauser
Parameter Prerequisite Description User interface Factory setting
Carrier volume flow With the following conditions:
• Order code for "Application
package", option ED
"Concentration"
• The Ethanol in water
option or %mass /
%volume option is selected
in the Liquid type
parameter.
• The %vol option is selected
in the Concentration unit
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the volume flow
currently measured for the
carrier medium.
Dependency
The unit is taken from the
Volume flow unit parameter
(→  109).
Signed floating-point
number
–
CTL For the following order code:
• "Application package", option
EJ "Petroleum"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the calibration factor
which represents the effect of
temperature on the fluid. This
is used to convert the
measured volume flow and the
measured density to values at
reference temperature.
Positive floating-
point number
–
CPL For the following order code:
• "Application package", option
EJ "Petroleum"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the calibration factor
which represents the effect of
pressure on the fluid. This is
used to convert the measured
volume flow and the measured
density to values at reference
pressure.
Positive floating-
point number
–
CTPL For the following order code:
• "Application package", option
EJ "Petroleum"
• The API referenced
correction option is selected
in Petroleum mode
parameter.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the combined
calibration factor which
represents the effect of
temperature and pressure on
the fluid This is used to convert
the measured volume flow and
the measured density to values
at reference temperature and
reference pressure.
Positive floating-
point number
–