Section 4 — Effects EPS-16 PLUS Musician's Manual
COMMAND/Effects Page
• The commands on this page allow you to copy and save effects.
This parameter is used to save the bank effect to disk (or hard drive) as a separate
file which can be reloaded at any time. Only the bank effect can be saved directly
to disk; conversely, when you load an Effect file from disk, it is always loaded
into the Bank Effect location. If you wish to save, as a separate effects file, either
a ROM effect or an Instrument effect, you must first copy the effect into the bank
effect (see below) and then save it
• Select SAVE BANK EFFECT.
• Press Enter•Yes. The display shows the filename associated with the current
Bank effect. You can rename the effect using the arrow buttons and the data
entry slider if you wish.
• Press Enter•Yes. The EPS-16 PLUS then saves the effect file to disk.
This command is used to copy an effect either from the bank to an instrument, or
the other way around. It can also be used to copy one of the ROM effects onto an
instrument or the bank. The effect that is copied (the source effect) is always the
one you are currently hearing.
• Select COPY CURRENT EFFECT.
• Press Enter•Yes. The display shows the DIRECTION parameter. Using the
Up/Down Arrow buttons, select either COPY TO BANK to take the effect
from the currently selected instrument and copy it into the bank, or COPY TO
INST to take the effect currently in the bank location and copy it to one of the
instruments in the internal memory.
• Press Enter•Yes. If you've selected COPY TO BANK in the previous step,
the display will briefly read COMMAND COMPLETED and the procedure will
be done. However, if COPY TO INST was selected, use the
Instrument•Track buttons to indicate into which instrument you wish to
copy the bank effect. Once the destination instrument has been selected, press
Enter•Yes.
4 - 18
To Next Page
Loading...
Need help?
General
