EasyManuals Logo

ENSONIQ EPS-16 PLUS Musician's Manual

ENSONIQ EPS-16 PLUS
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #176 background imageLoading...
Page #176 background image
Section 7 Voice Parameters EPS-16 PLUS Musician's Manual
COMMAND/Layer Page
These commands allow you to create, copy, and delete whole layers.
Use this command to create a new layer in the currently selected instrument
Select CREATE NEW LAYER.
Press Enter•Yes. The display reads LAYER ## CREATED.
Use this command to copy an existing layer and all the Wavesamples in it, either
within an instrument or from one instrument to another.
Select COPY LAYER. The display reads TO INST=UNNAMED INST.
Select the destination instrument. Press Enter•Yes.
Select COPY=PARAMS ONLY/PARAMS+DATA. It is a good idea to choose
PARAMS ONLY when copying a layer within the same instrument, allowing
the wave data to be shared. This will conserve memory. However, always
choose PARAMS+DATA when copying a layer from one instrument to
another, or else the destination instrument will not contain the wave data when it
is saved to disk, and subsequently reloaded.
Press Enter•Yes. The display reads LAYER ## CREATED.
Use this command to delete a layer in the currently selected instrument
Choose the layer you want to delete.
Select DELETE LAYER.
Press Enter•Yes. The display reads DELETE LAYER ##.
Press Enter•Yes or Cancel•No.
Note: If you get the message NO EDIT LAYER SELECTED, simply press Edit and
select the layer you want to copy or delete, and then proceed with the command.
7 - 32
COMMAND/Layer Page

Table of Contents

Other manuals for ENSONIQ EPS-16 PLUS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENSONIQ EPS-16 PLUS and is the answer not in the manual?

ENSONIQ EPS-16 PLUS Specifications

General IconGeneral
BrandENSONIQ
ModelEPS-16 PLUS
CategoryRecording Equipment
LanguageEnglish

Related product manuals