EPS-16 PLUS Musician's Manual Section 7 — Voice Parameters
ENVELOPE MODE has three states:
• NORMAL: as pictured in the previous envelope diagrams.
• CYCLE: envelope runs its full cycle, ignoring the key-up event.
• REPEAT: In this mode, the envelope will run through levels 2 through 5,
using times 1 through 4, repeatedly as long as the key is down.
The last parameter on the Envelope page usually reads ENVELOPE==CURRENT
VALUE. This is the envelope template parameter.
There are a number of "typical" envelopes permanently stored in the EPS-16
PLUS; they each have a name. When you select one of these envelopes, its
twenty-one parameters are copied into the envelope of the Wavesample or
Wavesamples you are editing. The old values are temporarily saved as the
CURRENT VALUE. You can go back to CURRENT VALUE any time you
wish, unless you change any of the values in one of the template envelopes.
Editing individual parameters of any envelope causes it to become the
CURRENT VALUE of that particular envelope.
The diagram on the following page illustrates the fourteen typical envelopes.
EPS-16 PLUS Envelopes
7 - 15
To Next Page
Loading...
Need help?
General
