Section 9 — Sequencer Edit Functions EPS-16 PLUS Musician's Manual
COMMAND/Track Page
These commands allow you to manipulate data on the individual tracks.
This command automatically corrects the timing of a track. After you have
recorded a track, the EPS-16 Plus can post-quantize the track and move the notes
to the nearest beat boundary. For example, if you set quantize to 1/4, all the notes
will be adjusted to the nearest quarter note. You can compare the quantized track
with the original track on the KEEP=OLD/NEW page, before deciding whether to
keep the results.
• Select QUANTIZE TRACK.
• Press Enter•Yes. The display reads TRACK=##. Select the track you want
to quantize by pressing one of the active Instrument•Track buttons.
• Press Enter•Yes. The display reads QUANTIZE TO ##. The quantize
values are: 1/4, 1/4T (triplets), 1/8, 1/8T, 1/16, 1/16T, 1/32, 1/32T, 1/64,
1/64T. Select a quantize value.
• Press Enter•Yes. The display reads ENTIRE TRACK. Pressing
Enter•Yes at this point will edit the entire track and place you on the
KEEP=OLD/NEW page. If you wish to edit only a portion of the track, press
the Up Arrow button until the display reads SET RANGES. You can then
press Enter•Yes and set both the key range and bar/beat range in which the
editing will take place. Upon completion of setting these ranges, the editing
will take place and you will be placed on the KEEP=OLD/NEW page. If
you've previously set editing ranges for the current song or sequence, you can
use the Up Arrow button to call up USE RANGES. Pressing Enter•Yes
will commence editing based on the previously set range values.
• Press Enter•Yes if you want to keep the quantized version of the track, or
Cancel•No to keep the unquantized track.
9 - 6
COMMAND/Track Page
To Next Page
Loading...
Need help?
General
