EPS-16 PLUS Musician's Manual
Section 9 — Sequencer Edit Functions
• With the track you want to edit selected, press the Command button,
followed by the Track button. The display shows:
This is the Event Locating Screen.
Event Cursor
When this field is selected, you can use the Data Entry Slider or Up/Down
Arrow buttons to step ahead or back in time among the events in the track to
find the one(s) you want to edit. When you press the Up/Down Arrow
buttons, it will advance to the next or previous event of the type specified in the
Event Type Filter. Moving the Data Entry Slider will scroll quickly through
all the events in the track. You will hear the notes in the sequence play as you step
through the track.
Current Event Type
This displays the current event type being viewed. This parameter is display only
and cannot be changed from this screen.
Key Name
This parameter displays the key name that is either being played (when Current
Event Type is Key Events "KY") or being affected by pressure (when Current
Event Type is Key Pressure "KP").
The Key Name parameter behaves in the same fashion as the Event Cursor
would, enabling you to use the data entry controls to scroll to the next or previous
event.
To change the Key Name for the current event, select the Key Name parameter
and play the new key on the keyboard.
Event Value
This shows the value of the current event. The values can be changed using the
Data Entry Slider or Up/Down Arrow buttons. These changes take place
as they are made.
Note: When the current event type is KEY EVNT, the event value refers to the keys
velocity value. When adjusting this value, you will notice that the Up/Down
Arrow buttons change the value by three or four, instead of one. This is due to
the velocity response of the EPS-16 PLUS and is perfectly normal.
COMMAND/Track Page
9 - 11
To Next Page
Loading...
Need help?
General
