EPS-16 PLUS Musician's Manual
Section 11 — Storage Functions
EPS-16 PLUS Disk Messages
WARNINGS
Warnings are displayed for one second and indicate either successful completion
or non-fatal error conditions encountered during a disk operation.
• DISK COMMAND COMPLETED — indicates that the disk operation was
completed successfully.
• DISK WRTTE-PROTECTED — appears during SAVE or DELETE operations
if the diskette is write-protected.
• DISK HAS BEEN CHANGED — appears when you begin to LOAD, SAVE
or DELETE when the disk in the drive has been changed since the last time the
EPS-16 PLUS loaded a disk directory.
• DISK DRIVE NOT READY — usually indicates that there is no diskette in the
drive, although it can indicate a hardware problem if it persists.
• NOT ENOUGH DISK SPACE — indicates that there are not enough available
sectors on diskette or hard drive to save the file.
• FILE DOES NOT EXIST — appears when you try to LOAD or DELETE when
the display shows FILE=NO <FILE TYPE>.
• NO SYS EX DATA TO SAVE — indicates that there is no data in the Sys-Ex
Recorder to save.
• FILE TOO LARGE TO LOAD — indicates that the sequence data in the disk
file will not fit into the free memory. Delete sequences or songs to make some
memory available. If that does not work, the file may have been saved from a
system with expanded memory.
ERROR MESSAGES
Error messages are always accompanied by the PRESS ANY BUTTON TO
CONTINUE... prompt, and remain on the screen until any button is pressed.
These messages indicate serious error conditions which interrupted the disk
operation. These errors may have prevented the correct saving or loading of the
data in the file(s).
• DISK DRIVE NOT RESPONDING — indicates either that there is no diskette
in the drive or that there are hardware problems.
• DISK NOT FORMATTED — the disk format was not recognized, and the disk
is either blank or formatted for some other system.
• NOT EPS-16 PLUS DISK — the disk format was recognized, but the disk
does not contain EPS-16 PLUS data.
MIDI Sys-Ex
11 - 19