1) Audio In
This jack is the audio input used for sampling into the EPS-16 PLUS. You can
switch between mic or line level by pressing the Left or Right Arrow button after
entering Level-Detect (VU) mode when sampling.
Specs: 91 KOhm input impedance, AC coupled Maximum input signal before
clipping: Line level= 0 dBV (2.828 Vp-p); Mic level= -28 dBV (.108 Vp-p).
2) Right/Mono
To operate the EPS-16 PLUS in stereo, connect this output to a channel of your
mixer and pan that channel right Note that either of the audio outputs can be
used as a mono output If you want to use this jack to listen to the outputs in
mono, make sure that nothing is connected to the Left/Mono jack.
3) Left/Mono
When operating the EPS-16 PLUS in stereo, connect this output to a channel of
your mixer and pan that channel left. To use this jack to listen to the outputs in
mono, make sure that nothing is connected to the Right/Mono jack.
4) Pedal/CV
This jack is for connecting an optional ENSONIQ Model CVP-1 Control Voltage
Foot Pedal, which is assignable as a modulator to various parameters within the
EPS-16 PLUS.
A CV pedal plugged into this jack can also act a volume pedal, controlling the
overall volume level of the EPS-16 PLUS. A parameter on the
EDIT/System•MIDI page (press Edit
7
then System•MIDI, then scroll until
the display reads PEDAL=VOLUME MIDI=7), determines whether the CV pedal
will act as a modulator or as a volume pedal. Set to PEDAL=VOLUME to use the
CV pedal to control the volume of the EPS-16 PLUS.
Pedal/CV Specs: 3-conductor (Tip=control voltage input, Ring=2 KOhm resistor
to +12 Volts, Sleeve= ground). 68 KOhm input impedance, DC coupled. Input
voltage range=0 to 10 volts DC. Scan rate=32mS (maximum recommended
modulation input= 15 Hz). For use with an external control voltage, use a 2-
conductor cable with the voltage on the tip and the sleeve grounded.
Rear Panel Connections
1 - 9
EPS-16 PLUS Musician's Manual Section 1 — Getting Started
Rear Panel Connections
To Next Page
Loading...
