ENSONIQ EPS-16 PLUS - Fade In.

EPS-16 PLUS Musician's Manual Section 6 — Wave Parameters
This command scales the volume of the wavedata from 0% to 100% to create a
digital fade-in of the sound. First, select a data range, using the start and end
addresses, then choose an appropriate fade curve. 3 dB fades are very smooth
and analogous to the way our hearing responds to sound.
• Select FADE IN. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##).
• Scroll to SCALE DEPTH=## DB. Press Enter•Yes.
• The display reads KEEP=OLD NEW.
• Press Enter•Yes to complete the command (or Cancel•No to keep the
original).
This command scales the volume of the wavedata from 100% to 0% to create a
digital fade-out of the sound. The parameters are the same as above.
• Select FADE OUT. Press Enter•Yes.
• Select START ADDR=## (##). Scroll to END ADDR=## (##).
• Scroll to SCALE DEPTH=## (##). Press Enter•Yes.
• The display reads KEEP=OLD NEW.
• Press Enter•Yes to complete the command (or Cancel•No to keep the
original).
COMMAND/Amp Page
6 - 27