ENSONIQ EPS-16 PLUS Musician's Manual

EPS-16 PLUS Musician's Manual Section 6 — Wave Parameters
This is a "sound sculpting" tool that will enable you to shape the volume contour
of the waveform. As in the other commands, you select some range of data using
the start and end addresses. You also set the scaling range with scale start and
scale end points. These are multipliers. Scale start is a multiplier used at the
beginning of the source range. Scale end is the multiplier used at the end of the
source range. If the two scale points are the same, it's like multiplying the whole
range of data by the same number. So, if you wanted to drop the level in half,
you would set scale start and end to 0.5. Scale depth works as described
previously. If the scale points are different, the data will be scaled using a scaling
curve whose depth is controlled by the scale depth.
• Select SCALE DATA. Press Enter•Yes.
• Select START ADDR=##(##). Scroll to END ADDR=## (##). Scroll to
SCALE START=##.
• Scroll to SCALE END=##. Scroll to SCALE DEPTH=## DB. Press
Enter•Yes.
• The display reads KEEP=OLD NEW. Press Enter•Yes to complete the
command (or Cancel•No to abort the procedure).
COMMAND/LFO Page
6 - 23

ENSONIQ EPS-16 PLUS Specifications

General

Brand	ENSONIQ
Model	EPS-16 PLUS
Category	Recording Equipment
Language	English