ENSONIQ EPS-16 PLUS Musician's Manual

Section 4 — Effects
EPS-16 PLUS Musician's Manual
CHORUS+REVERB
This effect combines a four-voice chorus with the standard reverb. Assign a
voice to BUS1 to get both chorus and reverb, or use BUS2 for reverb only. Use
BUS3 to bypass the effect (dry).
Bus1 Rev After Chor — Reverb After Chorus
Range: 00 to 99
This parameter determines how much of the signal that is sent to BUS 1 (the
chorus) will then also go to the reverb — it is a Reverb Mix for the chorused
signal.
Bus2 Reverb Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Reverb for voices sent to BUS 2.
Reverb Decay Time
Low Freq Decay — Low Frequency Decay
Diffusion
Hi Freq Damping — High Frequency Damping
Hi Freq Bandwidth — High Frequency Bandwidth
Reverb Detune Rate/Amt
See the description under Hall Reverb.
Early Reflection Lev — Early Reflection Level
Range: 00 to 99
Controls the level of pre-echoes of the input signal added directly to the reverb
output.
Chorus Rate
Range: 00 to 99
This parameter controls the four rates of modulation of the delay time of the
chorus. The delay modulation produces vibrato and tremolo.
Chorus Amt — Chorus Amount
Range: 00 to 99
This parameter controls the depth of vibrato and tremolo.
Chorus Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix within the chorus itself.
Chorus Feedback
Range: -99 to +99
This parameter controls the amount of feedback applied to the chorus. The sign
of the value determines the polarity of the feedback. Feedback accentuates the
complexity of the "swept" signal.
4 - 10
Effect Parameters

ENSONIQ EPS-16 PLUS Specifications

General

Brand	ENSONIQ
Model	EPS-16 PLUS
Category	Recording Equipment
Language	English