ENSONIQ EPS-16 PLUS - Section 6 - Wavesample Parameters

Section 5 — Sampling
EPS-16 PLUS Musician's Manual
• Most often you will find a loop which works fairly well except that the splice
point is noticeable. In this case, try performing one (or more) of the cross-
fades contained on the COMMAND/Wave page. Cross-fading can smooth out
the timbral differences between LOOP START and LOOP END, making the
transition less abrupt See Section 6 — Wavesample Parameters for more
details.
• A loud bump or "pop" at the splice point usually indicates a volume difference
between loop start and loop end Try VOLUME SMOOTHING the loop (see
Section 6 — Wavesample Parameters) before doing a cross-fade.
• Again, once you have a good loop, move the sample end back and then truncate
the Wavesample.
5 - 16
Looping