EPS-16 PLUS Musician's Manual
Section 4 — Effects
PHASER+REVERB
A 12-pole phase shifter with reverb. Assign a voice to BUS1 for phaser plus
reverb; to BUS2 for just reverb; and to BUS3 to bypass the effect (dry).
Bus1 Reverb Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Phaser into the Reverb.
Bus2 Reverb Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Reverb.
Reverb Decay Time
Low Freq Decay — Low Frequency Decay
Diffusion
High Freq Damping
Hi Freq Bandwidth
Reverb Detune Rate
Reverb Detune Amt
See the descriptions under Hall Reverb.
Early Reflection Lev — Early Reflection Level
See the description under Chorus+Reverb.
Phase Rate
Range: 00 to 99
This parameter controls the rate of modulation of the phaser poles.
Phase Width
Range: 00 to 99
This parameter controls the amount of modulation applied to phaser poles.
Phase Feedback
Range: -99 to +99
This parameter controls the amount of feedback applied to the phaser. The sign
of the value determines the polarity of the feedback.
Phase Depth
Range: 00 to 99
This parameter controls the depth of the notches created by the phasing.
Phase Center
Range: 00 to 99
This parameter controls the center of the phaser width.
Effect Parameters
4 - 11
To Next Page
Loading...
