Section 9 — Sequencer Edit Functions EPS-16 PLUS Musician's Manual
Use this command to transpose notes in a track by as much as an octave, up or
down.
• Select TRANSPOSE TRACK.
• Press Enter•Yes. The display reads TRACK=##.
• Select TRANSPOSE AMOUNT=## (Range -12 to +12 semitones).
• Select RANGE. Set the key and bar/beat ranges as described in earlier
commands.
• Press Enter•Yes. The display reads KEEP=OLD/NEW.
• Press Enter•Yes to complete the command (or Cancel•No to abort the
procedure).
Use this command to increase or decrease the effect of a controller in a track.
• Scroll to SCALE EVENT.
• Press Enter•Yes. The display reads TRACK=##.
• Scroll to SCALE=_. The controllers on this page include: KEY-VELOCITY,
MODWHL, PEDAL, VOLUME, SUST, PSEL, XCTRL, ALL
CONTROLLERS, CHAN-PRESSURE, MIXDWN-VOLUME, MIXDOWN-
PAN, and PITCH-BEND.
• Scroll to SCALE BY ##. The Data Entry Slider scales the controller by
whole values; the Up/Down Arrow buttons scale it by fractions. Values of
less then 1.00 will decrease the effect of a controller. Values greater than 1.00
will increase the effect of a controller in a selected track.
• Scroll to RANGE. Edit as described in previous commands.
• Press Enter•Yes. The display reads KEEP=OLD/NEW.
• Press Enter•Yes to complete the command (or Cancel•No to abort the
procedure).
This command allows you to shift all note events on a track forward or backward
in time. This can be useful for correcting MIDI delay, or creating a "lazy" or
"rushed" feel when a track is moved in time relative to other tracks.
• Scroll to SHIFT TRACKS BY CLOCKS.
• Press Enter•Yes. The display reads TRACK=##.
• Scroll to SHIFT AMOUNT=## (Range -96 to +96 clocks).
• Press Enter•Yes. The display reads KEEP=OLD/NEW.
• Press Enter•Yes to complete the command (or Cancel•No to abort the
procedure).
9 - 14
COMMAND/Track Page
To Next Page
Loading...
Need help?
General
