EPS-16 PLUS Musician's Manual Section 8 — Sequencer Basics
The EDIT/Seq•Song Page
This page acts as the main "control panel" for sequencing.
This screen is where you select a sequence or the song. With the selected
sequence or song underlined (as shown above), use the Up/Down Arrow
buttons or the Data Entry Slider to select a different sequence or song. You
can always get back to this screen by double-clicking the Seq•Song button
(when in EDIT mode).
The GOTO Function
• Press the Right Arrow button to move the cursor to the BAR parameter.
The display reads as follows:
This shows the current location in the selected sequence or song. When the
cursor is under the Bar (or Step) Number you can GOTO any location by moving
the Data Entry Slider to select a new location, then pressing Enter.
Pressing Play will always start the sequencer from the beginning of the
selected sequence. Pressing the Stop•Continue button will begin playing the
sequence from the selected bar.
EDIT/Seq•Song Page
8 - 7
To Next Page
Loading...
Need help?
General
