ENSONIQ EPS-16 PLUS Musician's Manual

Section 9 — Sequencer Edit Functions EPS-16 PLUS Musician's Manual
COMMAND/Seq•Song Page
Use this command to create a new sequence. See Section 8 — Sequencer Basics
for information on recording a sequence.
This command allows you to copy an entire sequence, including all tracks and
parameters in the sequence. COPY SEQUENCE lets you perform commands and
edits on the "copy" while preserving the source sequence.
• Select COPY SEQUENCE.
• Press Enter•Yes. The display reads FROM SEQ=SEQUENCE ##. Choose
your source sequence.
• Press Enter•Yes. The display reads NEW NAME=SEQUENCE ##. You
can use the data entry controls to change the name of the sequence, or use the
default designation.
• Press Enter•Yes to complete the command.
Use this command to erase unwanted sequences.
• Select DELETE SEQUENCE.
• Press Enter•Yes. The display reads SEQ=SEQUENCE ##.
• If this is the sequence you want to delete, press Enter•Yes.
Use this command to save the current sequence to disk.
• Make sure the sequence you want to save is selected.
• Select SAVE CURRENT SEQUENCE.
• Press Enter•Yes. The display reads NEW NAME=SEQUENCE ##. If you
want to rename your sequence, do so at this time using the data entry
commands.
• Press Enter•Yes. The display reads SAVING SEQUENCE ##, then DISK
COMMAND COMPLETED.
9 - 2
COMMAND/Seq•Song Page

ENSONIQ EPS-16 PLUS Specifications

General

Brand	ENSONIQ
Model	EPS-16 PLUS
Category	Recording Equipment
Language	English