Section 4 — Effects
EPS-16 PLUS Musician's Manual
FLANGER+REV
The Flanger+Reverb algorithm is similar to the Chorus+Reverb algorithm with a
single LFO. Assign a voice to BUS1 to get the flanger plus reverb, and use
BUS2 for reverb only. BUS3 is dry.
Bus1 Reverb Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Flanger into the Reverb.
Bus2 Reverb Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Reverb for signals sent to BUS2.
Reverb Decay Time
Low Freq Decay — Low Frequency Decay
Diffusion
Hi Freq Damping — High Frequency Damping
Hi Freq Bandwidth — High Frequency Bandwidth
Reverb Detune Rate
Reverb Detune Amt
See the descriptions under Hall Reverb.
Early Reflection Lev — Early Reflection Level
See the description under Chorus+Reverb.
Flange Center
Range: 00 to 99
This parameter controls the center of the flanger width.
Flange Rate
Range: 00 to 99
This parameter controls the rate of modulation of the flanger effect
Flange Width
Range: 00 to 99
This parameter controls the range of the high to low frequency sweep in the
flanger effect
Flange Feedback
Range: -99 to +99
This parameter controls the amount of feedback applied to the flanger. The sign
of the value determines the polarity of the feedback.
Flange Depth
Range: 00 to 99
This parameter controls the depth of the notches created by the flanging effect.
4 - 12
Effect Parameters
To Next Page
Loading...
