ENSONIQ EPS-16 PLUS Musician's Manual

EPS-16 PLUS Musician's Manual
Section 4 — Effects
ROT. SPKR+REV
A rotating speaker simulation with reverb and distortion. Assign a voice to BUS1
to get rotary speaker with distortion and reverb, and use BUS2 for reverb only.
BUS3 is a dry bus (no effect). There are selections on the Variations screen for
the Rotary Speaker without Distortion.
Bus1 Rev After Roto — Reverb After Rotary Speaker
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Rotary Speaker.
Bus2 Reverb Mix
Range: 00 to 99
This parameter controls the Dry/Wet mix of the Reverb from signals sent to
BUS2.
Reverb Decay Time
Hi Freq Damping — High Frequency Damping
Diffusion
See the descriptions under Hall Reverb.
Rotor Fast
Range: 00 to 99
Determines the rate of the rotary speaker when in the "Fast" setting.
Rotor Slow
Range: 00 to 99
Determines the rate of the rotary speaker when in the "Slow" setting.
Rotor Inertia
Range: 00 to 99
Determines how long it will take for the rotor effect to speed up and slow down
after switching from fast to slow or vice versa. Adjust this parameter to simulate
the effect of the rotary speaker gradually picking up speed.
Fast-Slow Switch
Determines how the rotary speaker will switch between slow and fast speeds.
There are several controllers that will act as the method for changing speed How
they change speeds fall into two categories:
• WHEEL, PRESS(ure), PEDAL, and XCTRL — These modulation sources act
like a potentiometer to turn on or off the fast rotor speed and adjust the speed to
a particular level. The switch accurately reflects an actual rotary speaker, taking
time to speed up or slow down, based on the value of the inertia parameter
above.
• SUSTN, FTSW2, PATCH — Every time the modulation source moves from
zero in a positive direction, the speaker effect changes speeds, from slow to fast
or fast to slow.
Effect Parameters
4 - 13

ENSONIQ EPS-16 PLUS Specifications

General

Brand	ENSONIQ
Model	EPS-16 PLUS
Category	Recording Equipment
Language	English