Section 11 — Storage Functions EPS-16 PLUS Musician's Manual
• Press Enter•Yes to send the data. The display will flash SENDING
DATA... When completed, the display will return to the QUIT/SEND screen.
• Check the receiving instrument(s) to see that the data was received correctly. If
it wasn't, make sure that:
> the MIDI connections are correct (EPS-16 PLUS' MIDI Out to the receiving
device's MIDI In),
> the receiving device(s) is enabled to receive System Exclusive messages,
> the receiving device(s) is set to the same MIDI base channel(s) as when the
data was initially sent to the EPS-16 PLUS.
Then press Enter•Yes again, and the data will be transmitted again. You can
keep repeating this until the data has been successfully received by the remote
device(s).
• Once the data has been successfully transmitted, press Cancel•No.
11 - 18
MIDI Sys-Ex
To Next Page
Loading...
Need help?
General
