Section 8 — Sequencer Basics EPS-16 PLUS Musician's Manual
Track Mix
The EPS-16 PLUS stores track mix information for each track of a sequence.
When you record a sequence track, the track mix will be recorded into the track.
When you play a sequence back, each track will have the correct volume balance.
After you've created a sequence, if you want to change the mix volume in a given
track:
• Go to the EDIT/Seq•Song page and set RECORD MODE to ADD.
• Go to the EDIT/Track page and set the track mix to the desired starting value. I
may help to play the sequence and adjust the mix while listening to the track
until you find the proper level.
• While holding down Record, press Play. After the first bar of the
sequence, press Stop•Continue.
• Select KEEP=NEW. You have now recorded a new mix volume in that track.
You can't audition the volume change on the KEEP=OLD/NEW page.
However, you will hear the volume change after you've chosen KEEP=NEW.
If you don't like the mix after you've chosen KEEP=NEW, simply repeat the
above procedure and set a new volume level.
• It's a good idea to return to the EDIT/Seq•Song page to set the RECORD
MODE back to REPLACE for later sequencing.
Mixdown
If you record a song track on an instrument that has sequence tracks defined, the
track mix information in the song track overrides the sequence information. In
addition, when you are recording a song track, any changes that you make to the
track mix during recording will be recorded in the song track. This allows you to
create fade in/out assignments while the sequence is in progress.
Track Pan
This parameter allows you to give a track in a sequence or song have specific
panning information, overriding pan information from the instrument
Range: -98 (Full Left) to +99; WS (Wavesample — when this is selected, the
track will use the panning information that is contained within the instrument).
This parameter allows you to override output information from the instrument and
send a track in a sequence or song to a specific output. See the description of the
Voice Out parameter in Section 7 — Voice Parameters for a complete description
of the EPS-16 PLUS' output routing scheme.
8 - 12
EDIT/Track Page
To Next Page
Loading...
Need help?
General
