EPS-16 PLUS Musician's Manual Section 8 — Sequencer Basics
• Press the Right Arrow button again to reveal the following display:
Here, for each step of the song, you can select Play, Mute, or Transpose for each
track of the sequence.
• "P" means PLAY - tracks that show a "P" will play normally,
• "M" means MUTE - selecting "M" for a track will silence that track during the
song step.
• "T" means TRANSPOSE - tracks that show a "T" will be transposed up or
down, by the amount shown to the right, for the duration of the step.
If you want to mute or transpose any of the tracks during that step, scroll until
that track is underlined, and use the Up/Down Arrow buttons to select M
(mute) or T (transpose) for that track.
If you have selected T to transpose any of the tracks during the song step, scroll
right to underline the Transpose Amount This can be adjusted in one-semitone
steps from -12 (down one octave) to +12 (up one octave). This control will only
affect tracks for which a T has been chosen at the right Conversely, if you
choose T status for one or more tracks but leave the Transpose Amount set at
zero, it will have no effect
• Press the Left or Right Arrow button to return to the first screen shown
above.
Once the sequence and number of reps is correct, press Enter•Yes to create step
one of the song. The display will briefly reads EDITING... then comes back
with step two showing:
Now repeat the above procedure to define step two of the song.
For each step, choose a sequence and a number of repetitions and then press
Enter•Yes to create the step.
• There is always one •UNDEFINED• step after the last step in the song.
Song Mode
8 - 21
Transpose Amount
(Only affects those Tracks
for which TRK="T.")
To Next Page
Loading...
Need help?
General
