Section 10 — Sequencer Applications EPS-16 PLUS Musician's Manual
To use the EPS-16 PLUS in MONO A mode, set it up as follows:
• Load one or more instruments into the EPS-16 PLUS.
• Press Edit, then System•MIDI. Scroll to MIDI IN MODE.
• Select MIDI IN MODE=MONO A.
• Press Edit, then Track. Scroll to MULTI IN MIDI MODE.
• Set each Instrument•Track MULTI IN MIDI CHANNEL to correspond with its
track number (Track 1 MULTI IN MIDI CHANNEL=1, Track 2 MULTI IN
MIDI CHANNEL=2, etc.).
• Set your guitar controller to send in MONO mode on channels 1- 6 (some
models have an easy shortcut for getting into this state).
• Connect the MIDI Out of the guitar controller module to the MIDI In of the
EPS-16 PLUS.
• Press Load on the EPS-16 PLUS to return to LOAD mode. (Remember—the
EPS-16 PLUS will only respond to program changes or select multiple
instruments when in LOAD mode.)
• Select an Instrument•Track either by pressing its front panel button or by
sending a program change from the guitar controller.
• You should now be able to play the EPS-16 PLUS from the guitar controller
with all the strings playing whatever instrument(s) are selected or stacked on the
front panel.
To use the EPS-16 PLUS in MONO B mode:
The procedure for using the EPS-16 PLUS in MONO B is essentially the same
except that now each MIDI channel plays its corresponding Instrumen•Track as
shown below.
EPS-16 PLUS Settings:
MIDI IN MODE-MONO B
Track 1 MULTI IN MIDI CHANNEL 1
Track 2 MULTI IN MIDI CHANNEL 2
Track 3 MULTI IN MIDI CHANNEL 3
Track 4 MULTI IN MIDI CHANNEL 4
Track 5 MULTI IN MIDI CHANNEL 5
Track 6 MULTI IN MIDI CHANNEL 6
Track 7 MULTI IN MIDI CHANNEL 7
Track 8 MULTI IN MIDI CHANNEL 8
Guitar controller Settings:
Mode-MONO
String #1 sends on Channel 1
String #2 sends on Channel 2
String #3 sends on Channel 3
String #4 sends on Channel 4
String #5 sends on Channel 5
String #6 sends on Channel 6
Global controllers sent on Chan. 16
10-4 Using the EPS-16 PLUS with a MIDI Guitar Controller
To Next Page
Loading...
