EPS-16 PLUS Musician's Manual Section 2 — System Control
This determines whether the EPS-16 PLUS will send and receive MIDI
controllers—pitch bend, mod wheel, pressure, volume, sustain, etc. When Off,
the EPS-16 PLUS will neither transmit nor receive MIDI controllers.
This parameter determines whether the EPS-16 PLUS will send and receives
MIDI System Exclusive messages, such as remote programming instructions or
Wavesample dumps. When OFF, the EPS-16 PLUS will neither transmit nor
receive System Exclusive messages.
Note: This parameter does not have to be on for the EPS-16 PLUS to record and store
Sys-Ex messages from external devices using its MIDI Sys-Ex recorder function
on the COMMAND/System•MIDI page.
This parameter enables (ON) or disables (OFF) the EPS-16 PLUS to receive
program changes over MIDI (the default is ON).
To Send a Program Change from the EPS-16 PLUS:
• Hold down an Instrument•Track button.
• While holding down the Instrument•Track button, "type in" the number
(from 1-128) of the desired program change on the numeric keypad buttons of
the EPS-16 PLUS; then
• Release the Instrument•Track button. When the button is released, the
program change is sent.
If the EPS-16 PLUS has been set to TRANSMIT ON= INST CHAN, the
program change will be sent on the MIDI channel of the instrument whose button
you held down while typing in the number. If it is set to TRANSMIT ON=
BASE CHAN, the program change will always be sent on the base channel.
Receiving Program Changes
What the EPS-16 PLUS does when it receives a program change depends on the
current MIDI IN MODE.
If the MIDI IN MODE = OMNI, POLY, or MONO A, incoming
program changes 1-24 will Select, Deselect, or Stack the eight
Instrument•Tracks of the EPS-16 PLUS in the following fashion:
• Program changes 1-8 will Select EPS-16 PLUS Instruments 1-8 (LED will
turn yellow), if received by an instrument which is not selected.
EDIT System•MIDI Page
2 - 9
To Next Page
Loading...
