SmartROC T35/T40 24 Storage
156 No: 7026962571.1.7027002891 en-US
24.1.3 Preparing Rock Drill for Long-Term Storage
1.
Remove the rock drill.
2.
Apply corrosion inhibitor (For example, Tectyl 506) to the machined surfaces.
3.
Apply touch-up paint to any scratches and damage on painted areas.
24.1.4 Preparing Water Mist System for Long-Term Storage
1.
Drain the water mist system.
2.
Rinse with anti-freeze.
3.
Blow dry the water mist system with compressed air.
24.2 Restoring after Long-Term Storage
• Change lubricant and hydraulic oil where appropriate.
• Change filter and drain water separators where appropriate.
• Inspect joints, bushings, and splines for corrosion. Remedy any corrosion by cleaning
or replacing components.
• To remove any moisture binding from lubrication points: Pump new grease into the
grease nipples and apply grease with a brush to splines and sliding surfaces. Use the
correct grease for each point.
24.3 Inspection and Maintenance during Long-Term
Storage
• Check levels for oils and coolants.
• Start the diesel engine and run until the normal operating temperature is reached.
• Operate the machine a few metres back and forth so that the tramming gears are lubri-
cated.
• Operate the tilt cylinders, boom, feed, drill rod support, and rod handling until all cylin-
ders reach their end positions.
• Drain condensed water from the hydraulic oil tank and compressor oil tank.
• Rotate the electric motors a few turns at least every three months to avoid spot dam-
age on motor bearings.
To Next Page
Loading...
Need help?
General
