SmartROC T35/T40 17 Compressed Air System
107 No: 7026962571.1.7027002891 en-US
2.
Remove drain plugs for compressor tank, compressor cooler, and compressor ele-
ment and drain the oil.
3.
Install and tighten the plugs.
4.
Remove the oil filters (D).
5.
Open the cover plate (A) on the air reservoir and remove the oil separator element.
6.
Check inside the oil reservoir (B).
è
If sediments are detected, the parts (A, B, and C) must be thoroughly cleaned
before the procedure is completed.
7.
Insert a new oil separator element and install the cover plate (A).
8.
Clean the filter seat on the manifold using new oil, and make sure that no dirt falls
down into the system.
9.
Lubricate the gasket on the new filters with new oil.
10.
Replace the filters (D) and close the valve.
11.
Fill the oil reservoir with the minimum amount of oil permissible through the oil inlet
(E).
12.
Run the compressor that is unloaded in light mode for 30 minutes.
13.
Drain the oil.
14.
Fill the system with new oil.
The indicator on the gauge (F) must be in the upper section of the green zone.
15.
Run the compressor without load in light mode for 15 minutes and check for leaks.
16.
Check that the oil level on the gauge is in green zone. Top up if necessary.
17.12 Troubleshooting Air Compressor
Use the troubleshooter to help solve mechanical problems. It is assumed that the diesel
engine is in good condition.
To Next Page
Loading...
Need help?
General
