Epiroc SmartROC T40 Maintenance

SmartROC T35/T40 11 Dust Collector
56 No: 7026962571.1.7027002891 en-US
11.2 Check Dust Collector Tightening Torque
n
Check the tightening torque on bolts (A).
11.3 Checking Function of Dust Collector
Factory setting is 4-6 pulses during cleaning time.
Precondition
p
The air pressure must be less than 8 bar (manual valve).
1.
Turn the ignition key to ignition position. Set the mode selector (A) to drill mode
on the operating panel.
2.
Activate the dust collector by pressing the button (C). Make sure flush air (B) is in po-
sition “Reduced flush air”.

Epiroc SmartROC T40 Specifications

General

Brand	Epiroc
Model	SmartROC T40
Category	Industrial Equipment
Language	English