SmartROC T35/T40 9 Feed Unit
33 No: 7026962571.1.7027002891 en-US
9.3 Feeder 6000-Series
The hydraulic feeders on the BMH 6000 series are primarily intended for drift and tunnel
drilling. The feeders are available in different versions depending on the rock drill installed
on them.
The different numbers are explained, for example, BMH 6618.
The first number states the type of feed: 6 = 6000 series.
The second number states the type of rock drill for which the feeder is intended:
• 3 = COP 1840
• 3 = COP 1840
• 6 = COP 2150/60
• 8 = COP 2540/60
The third and fourth number states that the length of drill rods in feet. For example, 18 = 18
feet.
To Next Page
Loading...
Need help?
General
