SmartROC T35/T40 16 Control System and Sensors
97 No: 7026962571.1.7027002891 en-US
16 Control System and Sensors
16.1 Remote Control Batteries
• The remote control batteries must be fully discharged and then fully recharged regu-
larly.
• Charging can only take place in the temperature range of +10 °C to +40 °C (+50 °F to
+104 °F).
• NiCd batteries can be partially charged or discharged before arrival. Batteries must al-
ways be fully charged before use.
!
NOTE: Protect the batteries against short circuiting. Do not store them in a tool box or
loose in a pocket together with metal objects as these can short circuit the battery.
16.2 Cleaning Remote Control
The remote control may require cleaning. It is important that the remote control is not dam-
aged.
• Make sure the active stop on the remote control is not blocked by dirt or similar.
• The battery contacts should be cleaned and lubricated at regular intervals.
• To clean the remote control use a damp rag or a fine brush to remove dirt and dust.
!
NOTE: Never clean the remote control using high-pressure or steam washing. Strong
chemicals can destroy the remote control rubber bellows.
To Next Page
Loading...
Need help?
General
