Epiroc SmartROC T40 - Replace Engine Oil; Replace Engine Oil Filter

SmartROC T35/T40 13 Diesel Engine
76 No: 7026962571.1.7027002891 en-US
13.12 Replace Engine Oil
Precondition
p
Machine is placed on flat surface.
1.
Switch off the engine and allow the oil to drain down from the engine’s internal parts
for some minutes.
2.
Place a vessel under the drain plug.
3.
Remove the drain plug and drain all oil.
4.
Fill oil up with recommended amount.
5.
Oil level should be close to top mark on the dipstick. Top up if oil level is low.
6.
Start the engine and allow it to idle for about two minutes.
7.
Check the engine oil pressure.
8.
Check for leaks.
9.
Stop the engine and check oil level. Top up if necessary.
13.13 Replace Engine Oil Filter
WARNING
Burning Hazard
Hot components can cause serious personal injury.
u Turn off the machine before starting maintenance work.
u Be careful when draining hot oils and fluids.
u Use personal protective gear.
u Do not handle flammable fluids near hot surfaces, sparks, or open flames.