Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 128
Confidential
Align the positioning holes (x1) of the Main Board Unit with the
dowels (x1) of the Base Frame. (See
Fig. 4-42.)
Align the dowels (x2) of the Main Board Unit with the
positioning holes (x2) of the Holder IC Shield Plate. (See
Fig.
4-42.)
Align the dowel (x1) of the Main Board Unit with the
positioning hole
(x1) of the Right Cable Frame.
(See
Fig. 4-42.)
Insert the rib (x1) of the Grounding Plate M/B to the hole of the
Main Board Unit, and align the positioning hole (x1) of the
Grounding Plate M/B with the dowel (x1) of the Main Board
Unit, and then attach the Grounding Plate M/B. (See
Fig. 4-42,
Fig. 4-43.)
Figure 4-43. Attaching the Grounding Plate M/B
Hole
Rib
Grounding Plate M/B
When attaching the CR Encoder FFC, follow the procedure
below.
1. Put the CR Encoder FFC through the ferrite core.
2. Connect the CR Encoder FFC to the connector (CN6) on
the Main Board.
3. Insert the rib of the Ferrite Core Holder B to the hole of the
Main Board, and secure it with the screw (x1).
Figure 4-44. Attaching the CR Encoder FFC
For routing cables and FFCs, see "4.4 Routing FFC/cables"
(p.196).
C.B.S. 3x6 (5±0.5Kgfcm)
CN6
CR Encoder FFC
Ferrite core
Ferrite Core Holder B
Align and insert the rib of
the Ferrite Core Holder B
To Next Page
Loading...
