Epson Artisan 730 - Page 312

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 312
Confidential
7. Remove the screws (x2) that secure the Left Hinge.
Figure 9-49. Removing the Panel Unit (2)
8. Lift the Panel Unit and pull out the Panel FFC from the Panel Unit, and then
remove the Panel Unit.
Figure 9-50. Removing the Panel Unit (3)
9. Insert the tweezers or the like into section A and peel off the Panel Sheet.
Figure 9-51. Removing the Panel Unit (4)
Panel Unit
C.B.P. 3x10 (6±1Kgfcm)
Dowel
Left Hinge
Upper Housing
C.B.P. 3x10 (6±1Kgfcm)
Panel Unit
Panel FFC
 When installing the Panel Unit, align the dowels (x2) of the
Upper Housing with the positioning holes (x2) of the Left Hinge.
(See
Fig. 9-49 (p.312).)
 Taking the bottom left corner of the Panel Sheet as the
reference point, align the bottom edge with the bottom rib of the
Panel Unit and put the left edge against the rib, then attach the
Panel Sheet. (See
Fig. 9-51 (p.312).)
 Secure the Panel FFC and ferrite core to the Panel Shield Plate
with double-sided tape. (See
Fig. 9-43 (p.310).)
 Fold the Panel FFC at the fold line, and route it through the
marking on the Panel Shield Plate. (See
Fig. 9-47 (p.311).)
Panel Sheet
Panel Unit
Section A
Reference point
for the panel
sheet attachment