System 5 Digital Audio Mixing System Operation Manual Linking
134
9.5 Joystick Linking
Linked channels can be controlled from a joystick panner. A common application is us-
ing the joystick to control the pan for several Linked channels. The joystick panel has
a Link key above the Solo key(see Joystick Module on page 224).
9.5.1 Setting Joystick Links
To set up a Link from the joystick without existing channel Links:
1. To enter Link mode, hold down the Wave key and press the joystick’s Link
key.
The Link key flashes and the joystick displays ?? in the channel display.
2. Press the Link key on any channel to link it to the joystick.
That strip enters Link mode. Panners are automatically included in the default
scope.
3. Press Link keys on additional channels to add them to the Link.
4. Hold down the Wave key and press the joystick’s Link key (or the Link key
on any of the selected channels) to exit Link mode.
The joystick Link key stays lit to indicate it controls the link.
To set up a Link from the joystick with existing channel Links:
1. Hold down the Wave key and the press the joystick’s Link key.
The Link key flashes and the joystick displays ?? in the channel display.
2. Press the Link key on any channel already in a Link.
That channel is Linked to the joystick. Strips for all Linked channels enter Link
mode.
3. Add channels to the Link by pressing their Link keys.
Panners are automatically in scope if they were not already.
4. Hold down the Wave key and press the joystick’s Link key (or the Link key
on any of the selected channels) to exit Link mode.
The joystick’s Link key stays lit to indicate it controls the link.
To Next Page
Loading...
Need help?
General
