System 5 Digital Audio Mixing System Operation Manual Control Groups and Multi Format Masters
138
10.1.2 Assign Control Group to Strip
Assigning a Control Group to a Strip is identical to assigning any other channel; Groups
appear in the list when assigning a channel (see Section 8.1.1 - Map Channels and Con-
trol Groups to Strips). The Master LED lights when a Control Group is assigned to a
channel.
10.1.3 Modify Control Group
1. Press the Mod key at the bottom-left of the Groups Panel (Figure 10-1).
The Mod key flashes.
2. Press the Control Group key to be modified.
The Control Group key flashes to show it is ready to be modified. The Chan
Select keys flash for all channels assigned to that Control Group. The appro-
priate Swap/Main must be active to see the Chan Select key flash.
3. Press the flashing Chan Select keys to delete them from the Control Group and
non-flashing Chan Select keys to add them.
4. Exit this mode by pressing Mod again, another Control Group key, or any key
that accesses the Panel Viewer.
10.1.4 Name Control Group
1. Press the Name key at the bottom of the Groups Panel.
The Name key begins flashing.
2. Press the key for the Control Group you wish to rename.
3. Name the Control Group from the keyboard (maximum four characters).
10.1.5 Clear Control Group
1. Press the Clr key at the bottom of the Groups Panel.
The Clr key begins flashing.
2. Press the key for the Control Group you wish to clear.
All slaves are deleted from the Control Group, the name reverts to the default
(G#), and the display dims to show it is empty.
To Next Page
Loading...
Need help?
General
