System 5 Digital Audio Mixing System Operation Manual CM403 Film/Post Module
225
15.3.2 Joystick Assign Mode
Figure 15-12 Joystick Assign Mode
Cycle: Selecting a channel using the Wave key assigns it to the left joystick. Selecting
a second channel within 2.5 s assigns it to the right joystick.
Direct Assign: Hold a channel’s Wave key down and select Pan To: to assign that
channel to the left joystick. Hold the Wave key down and select the Pan knobset key
to assign the channel to the right joystick.
402 Cycle: Assigns channels to the joystick using the channel select keys on the
CM402T’s channel select panel. Selecting a channel assigns it to the left joystick. Se-
lecting a second channel within 2.5 s assigns it to the right joystick.
15.3.3 Layouts
Joystick assignments can be stored/recalled with Layouts and can also be protected
from Layouts using Strip Lock in the Strip Config Panel (see page 101).
15.3.4 Setting the Automation Mode for a Joystick
Set the automation mode for pan and surround parameters controlled by the joystick the
same as a standard strip: Hold down the joystick’s Wave key and press its Select/Punch
key repeatedly to cycle through the automation modes (Isolate, Write Absolute, Read).
The automation mode can also be set by pressing the desired automation mode key on
the CM401T (i.e., Write Abs), which puts the console into a select mode. Then press
the joystick’s Select/Punch key.
Strip Config 3
Joystick Assign Mode
Cycle
Direct Assign
402 Cycle
The Joystick Assign Mode can be found on page 3 in the Strip Config Panel (see
Figure 15-12).
To Next Page
Loading...
Need help?
General
