EasyManuals Logo

Euphonix System 5 User Manual

Euphonix System 5
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
System 5 Digital Audio Mixing System Operation Manual eMix Application
60
4.8 Masters
See Chapter 7: Busses and Bus Masters.
4.9 Conform
See Automation Conform on page 209.
4.10 Events
See Chapter 13: GPI/O Event System.
4.11 System 5 Logo
Clicking on the System 5 Logo in the lower right corner of the eMix screen will display
software version information and shutdown options.
4.12 Auto Failover
When Auto Failover is checked (enabled), any fault or potential primary DF-66
failure detected by the diagnostics system will switch the entire input audio path
over to the backup DF-66 Super Core. Clicking on the Restore to Primary DSP
button will switch the entire audio path back to the primary DF-66.
4.13 Control Panel
Clicking on the Control Panel Button brings up the Euphonix Control Panel. From
this panel, you can change the sample rate, sync sources, IP addresses, DSP card
MADI channel configuration (56 or 64 channels), and Multi-Operator Status of the
attached DF-66 Super Cores. DF-66 software versions are viewable from the Control
Panel, and a DF-66 Restart button is provided.
To find out how to change the console sampling rate, see Changing Sampling Rate on
page 55.
4.14 View Log
Clicking on the View Log button brings up the Diagnostic Log. Euphonix console
network communication failures and recoveries will be listed in the Diagnostic Log,
along with other console component error status’.

Table of Contents

Other manuals for Euphonix System 5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Euphonix System 5 and is the answer not in the manual?

Euphonix System 5 Specifications

General IconGeneral
BrandEuphonix
ModelSystem 5
CategoryMusic Mixer
LanguageEnglish

Related product manuals