System 5 Digital Audio Mixing System Operation Manual Layouts and Snapshots
145
11.1.2 Recall a Layout
To recall a single Layout:
1. If the RCL key is not lit, press it once so it flashes.
2. Press the location key for the desired Layout.
The Layout reconfigures the console surface and the RCL key turns off.
It can be useful to recall several Layouts consecutively to decide which to work with:
1. If the RCL key is not lit, press it twice so it illuminates but does not flash.
If the RCL key is flashing, press it once.
2. Press the location key for the desired Layout.
The Layout reconfigures the console surface and the RCL key remains illumi-
nated for another Recall selection.
11.1.3 Modify a Layout
1. Press the Mod key at the bottom of the Layout Panel so it flashes.
2. Press the key corresponding to the Layout you wish to modify.
The key begins flashing and the Wave keys for Strips in this Layout illuminate.
3. Press an illuminated Wave key to exclude a Strip currently in the Layout.
4. Press an unlit Wave key to include a new Strip in the Layout.
The Wave key begins flashing.
5. Press the Layout’s key again to store changes to this Layout.
6. Press the Mod key again to exit the modification process.
11.1.4 Rename a Layout
1. Press the Name key at the bottom of the Layout Panel so it begins flashing.
2. Press the key corresponding to the Layout to rename; that key also flashes.
3. Use the console keyboard to rename the Layout (eight characters maximum) and
press Enter to exit the process.
You can also press the Layout’s key or the Name key again to store the new
name and exit the renaming process.
To Next Page
Loading...
Need help?
General
