System 5 Digital Audio Mixing System Operation Manual Channels and Strips
97
8.1.1 Map Channels, Control Groups, and Busses to Strips
Each Strip can control a Main and Swap channel. One or both of the channels can be a
Control Group or Bus instead of a normal channel. Channels can be assigned individu-
ally using the Strip controls or to multiple Strips using the Channel Assign Panel
Individual Assignment: Strip Controls
The Chan Select key can be used to assign individual channels to a Strip on the console
surface:
1. Access the Main or Swap level to assign the desired channel.
2. Press and hold down the Wave key and press the Chan Select key.
The channel list appears on the meter bridge screen at the top of the Strip.
Control Groups that have been created, Aux Busses, Mix Busses, Mix Sec-
Accept and Abort keys
Figure 8-2 Strip controls during channel assignment
3. Use the fader to scroll through the list of channels, Control Groups, and
Busses on the screen; the highlighted entry is selected.
4. Press the Accept key to assign the selected channel or the Abort key to cancel.
To assign the Swap channel, press the Swap key and begin with step 2.
C1
C25
Channel Select
key
Abort Channel
selection
Accept Channel
selection
Wave
key
Fader scrolls
through
list
(page 98) or the Busses Assign Panel (page 99).
tions and Group Busses also appear in the list. The
flash (see Figure 8-2).
To Next Page
Loading...
Need help?
General
